Traccar doesnt accept positions but starts get them after restart
Try this version:
Thanks, now i installed 6.4 (stable) version, and set protocol.timeout (10 minutes).
If this step will not resolve my problem i try install preview ver and report about it.
I have been facing the same problem for 4 days with 6.4 version
it looks like the server is not accepting the new positions, after restart the server the route history saved by the device starts and is accepted by the server and displays the activities the vehicle did 2-3 hours ago. and the other thing i noticed is that you only have from one device, when it is fully updated and synchronized with the time, it starts pulling all the history from the next device
Have you tried the preview?
Rafail Stratiotis, do you have a speed limit in config file?
Anton Tananaev
what do you mean?
diagnoz
Νο
now that I'm writing to you, all the gps have stuck at 8 o'clock in the morning, now when i restart the server it will get all the information that it didn't get from 8 in the morning
I mean the preview version of Traccar. Have you read the thread from the start?
https://www.traccar.org/blog/traccar-6-4/
yes, i always read the blogs
i have version 6.4 installed and i am facing this problem
i will try to uninstall it and install it
I'm confused by the comment. I'm asking you to read this thread and try the preview version of Traccar. The link is provided earlier.
I didn't realize it's a different version sorry
i will try it now
Traccar ver: 6.3
Devices count: 15
Users count: 1
When I start server all works good.
But after one hour the server stops accept BULK (package that have for example 5 or 20 positions) positions from server.
When I restart the server it starts accept all coordinates (and BULK too).
I looked to log and see, that bulk data logs, and that bulk contains good coordinates (lat, lon e.t.c.), BUT after than I dont see that server decode coordinates, look like server jut filter them.