Hi all. I have been using a SinoTrack ST-901 (2G) in my car for several months and it's been working perfectly. I have now installed the 4G version (ST-901L) in my motorbike but the device keeps going online / offline every ~5 minutes even when I'm not using my bike.
The one in my car goes online / offline just once in the day when I don't use it.
I have them both physically wired the same way with the orange wire to a switched live and the other 2 wires to the battery. I have also (I think I have anyway) configured both of them in the same way, although when I do a RCONF I get a slightly different output on my bike one and I cannot figure out which commands to run to make it match my car one.
Anyone know what commands I may need to send it to make it behave like my car one? I want the device to stay in sleep mode until I turn the ignition on and then I want it to report every 7 seconds. When the ignition is turned off I want it to sleep 5 minutes after this point.
Attached RCONF of my bike one which I want to match my car one. The devices are slightly different models (2g / 4g) so I realise the RCONF may not look identical but there's something which keeps waking my bike one up every 5 minutes..
Any ideas much appreciated!
Cheers,
Jake
Bike in Traccar below
Bike RCONF below (I want this to match my car one as closely as possible)
Car RCONF below (this one works perfectly)
Hi all. I have been using a SinoTrack ST-901 (2G) in my car for several months and it's been working perfectly. I have now installed the 4G version (ST-901L) in my motorbike but the device keeps going online / offline every ~5 minutes even when I'm not using my bike.
The one in my car goes online / offline just once in the day when I don't use it.
I have them both physically wired the same way with the orange wire to a switched live and the other 2 wires to the battery. I have also (I think I have anyway) configured both of them in the same way, although when I do a RCONF I get a slightly different output on my bike one and I cannot figure out which commands to run to make it match my car one.
Anyone know what commands I may need to send it to make it behave like my car one? I want the device to stay in sleep mode until I turn the ignition on and then I want it to report every 7 seconds. When the ignition is turned off I want it to sleep 5 minutes after this point.
Attached RCONF of my bike one which I want to match my car one. The devices are slightly different models (2g / 4g) so I realise the RCONF may not look identical but there's something which keeps waking my bike one up every 5 minutes..
Any ideas much appreciated!
Cheers,
Jake
Bike in Traccar below
Bike RCONF below (I want this to match my car one as closely as possible)
Car RCONF below (this one works perfectly)
