q50 smartwatch without positions

Ronaldo5 years ago

hello, I have a smartwatch q50 that is connected to the traccar through port 5093, but does not inform the positions.

LOG:

3G*3304287939*008A*UD,230320,004331,V,00.000000,N,0.0000000,E,0.00,0.0,0.0,0,29,92,0,0,00000000,3,255,724,31,16803,46979,121,16803,13817,122,16803,13819,119]
Anton Tananaev5 years ago
  1. Are you sure it's the full log?
  2. What is your question?
Ronaldo5 years ago

Hi Anton:

Yes, I'm sure the log is complete up to that point.

My question is: why is the status window empty, even though the smartwatch is connected?

The smartwatch is in LBS mode. Is it related?

LOG:

2020-03-22 22:43:37  INFO: [e8864240: watch < 191.47.184.128] HEX: 5b33472a333330343238373933392a303037412a55442c3233303332302c3031343333342c562c30302e3030303030302c4e2c20302e303030303030302c452c302e30302c302e302c302e302c302c36302c39322c302c302c30303030303030302c322c3235352c3732342c33312c31363830332c31333831372c3133312c31363830332c31333831392c3131395d
2020-03-22 22:43:37  INFO: Position filtered by Invalid Zero filters from device: 3304287939
Anton Tananaev5 years ago

I think if you carefully read the log, you will see the answer.

Ronaldo5 years ago

Forgive me if for me it is not as logical as for you Anton, as I did not program TRACCAR, not everything I can interpret.

Ronaldo5 years ago

Previously, I mentioned that the smartwatch is in LBS mode, as I understand that the time, coordinates and others are sent by GPS mode.

Is it related to LBS?

Anton Tananaev5 years ago

There are only two lines in the log. One clearly says that your message was filtered out by the filters that you have configured in the config file.

Ronaldo5 years ago

Thanks for the reply Anton ...

If I am correct, this filter serves not to ask for geolocation when one coordinate is too close to another coordinate.

But since the first connection, there has never been any information for which the filter occurs. Also previously, I walked with the device for about 1 hour, but nothing has changed ...

when I set up the smartwatch for the setracker (native platform) everything works ... but when I go back to TRACCAR, I don't see anything else.

Anton Tananaev5 years ago

There are many filters available. The ones that were used have nothing to do with what you just said. I recommend you to study documentation a bit more to understand what each configuration parameter means and how Traccar works.

Ronaldo5 years ago

On its website, I found:

https://www.traccar.org/configuration-file/

Is this the complete documentation for all parameters?

If not, could you tell me where I can find it?

Ronaldo5 years ago

hello Anton,

After a lot of studying and testing, I finally managed to make the status window display information from the smartwatch.

Now the problem is different:

I am not able to see the location of the device despite having configured the geolocation parameters ...

what am I missing?

Thanks.