problem movement reports trips, stops, summary, engine hours
I do not know if due to the correct spelling to things that can be misinterpreted, I leave this message to clarify in case they do not understand the doubt
in the report section when you see the (trips, stops, summary and engine hours reports) are not accurate with those made by the device,
and the person who can provide me with the lines to configure the movements, trips, stops and engine hours I am totally grateful
You should check the route report to see the raw data for the same period.
Kind regards Anton, I have a doubt is that I have 10gps of the same model and configured of the same model they are gps 403b coban port 5001, but when I go to check the engine hours in almost all of them it does not show me the engine hours report that is i run on every gps,
https://prnt.sc/OC7hgPFC7QN5
but in the Device Status section in each device I consulted above, it actually shows me the engine hours that have been executed in the day.
I am attentive to any suggestion.
It should be noted that it is in most of my devices when the engine hours query appears as 0.0 hours and in others it shows me the correct time of hours.
I have the same setup and report setup on each of the 10 devices.
I already gave my suggestion, but it seems like it was completely ignored.
I was looking thoroughly at what you suggested to me and it is indeed correct Anton, I will also be attentive to these reports to understand them well as is the processing of the information also very kind for your answer totally grateful.
cordial greeting I wanted to write to the community to ask for their support and be totally grateful to whoever can clarify my doubt
I present a doubt in the section of consulting reports and specifically in Engine Hours.
I could also see that the information obtained in reports of movement, stops and trips in the are completely accurate.
because they do not mark me as I should be, having to configure the devices with the correct time zone.
Context:
In the reports of my device when I want to check how long the engine has been running 0.0 Attach image.
https://prnt.sc/uO0ty6LHRwZI
But in the Device Status window on the web, I do indeed see the total time of the vehicle's engine work
https://prnt.sc/VwbAUZ9YA-Kh
The problem that I present is that no matter what type of report I am going to consult, the engine hours are 0.0 and the reports that
I see are not accurate. (report of trips, stops, summary and engine hours)
I was reading the documentation and there is information on how to modify these parameters, but I don't know how the general line would be
which must be written and saved in the xml, create this thread to request the help of someone who has had a similar problem
and can you leave me the lines with the parameters which I must add in the xml.
I am totally grateful to the person who can help me in my doubt by providing me with the example lines and I can
modify to my need to do it in the right way.
I currently use traccar 5.0