LMU 3030 Support
I don't know what PEG script is. Port number for all CalAmp devices in Traccar is 5082, so you need to configure you unit to send data to that port.
Do you have access to the software Puls of calamp?
I have access to their wiki pages and documentation. Is that what you mean?
No, Puls is a software for program of the LMU3030.
You create a Peg in the LMUManager and sent to LMU3030 by Puls
I don't have any CalAmp devices, so I don't really need it. All I'm interested in is protocol documentation.
James,
I can help you with getting your device set up with a PEG script.
I need some help about PEG script. I want to setup my device.
Friend James, I put a CalAmp in traccar but report slow, how change the speed of fix?
Can you help me?
I use this commands:
APN: !R1,2306,0,yourapn.com
Disable auto-provisioning: !R1,1024,35,1,1
Inbound IP Address: !R1,2319,0,xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP Address)
Inbound Port: !R1,769,0,yyyy (where yyyy is the port number)
Reset: !R3,70,0
Status: !R0 (This will cause the unit to reply to your phone)
Very thanks...
I guess what you meant to ask is how to increase the frequency of reporting.
Yes, the tracker send position every 4 o 5 minutes, I need the sms to activate digital output to activate a relay too.
Thanks
Inetsof,
Can you send me your peg script? I can show you how to change reporting and enable SMS messages to trigger digital relays
Rock,
I can help you out. Do you still need help?
Jhutch,are you able to help me with script creation? I'm so lost.
Sure pass me over what it is that you're trying to do and I can help you get started. My email jhutch2342@gmail.com
What model of device are you using?
I have a LMU-3030 and it requires a PEG script to be loaded on the device to report. I have it working with other software. How do you setup the device to work with Traccar?