Tracker showing in the sea 2/3 timer per week
I think you forgot to mention what device you're using.
How about checking the log at that time / date to see if the device actually sends zero coordinates. In that case you can the filter it out.
You can filter it out by using "filter.zero" in your config.
Filter zero coordinates. Zero latitude and longitude are theoretically valid values, but it practice it usually indicates invalid GPS data.
Sorry its a Jimi IOT JC400P using port 5023.
Im try to check the log now
in the correct position have 26.037665° -80.248363°
on the wrong position have -26.037665° 80.248363°
Very strange change the - in the coordinates
Looks like a hemisphere issue. If all your devices are in the same hemispheres, you can use configuration to override it.
Thanks Anton, so i need to try to add this line at the config right??
<entry key='location.latitudeHemisphere'>N</entry>And restart the traccar service?
<entry key='location.longitudeHemisphere'>W</entry>I think need to add also this one
https://prnt.sc/5gT5ifoaJYWK
With this 2, now its ok, the last thing its the speed
Still showing 4637.92 mph, are any way to fix this???, also the vehicle is stopped with the engine off.
Thanks
You can use computed attributes to do something about the speed, but not sure what to do. Maybe just zero it if it's too high.
Ok, i going to read what its computed attributes to see how i can fix this. Many thanks
Hi i have some GPS, showing them in the middle of the see, are any way to send a reboot command or do something to show in the correct place???
If i send a Reboot command the GPS restart and show the right position on the map.
https://prnt.sc/FJgqGl3uFwP6
Thanks