OBDII data reception with teltonika FMC920
How about reading the documentation ?
Actually you don't need to do anything. If your device is sending it, you will see it. Some of the information might be displayed as generic IO values, in which case you need to check against Teltonika documentation to understand the value.
Indeed, for the I/O parameters it receives the data without problems by configuring the teltonika, but when I perform the same procedure in the OBDII tab I do not receive the data.
As far as I know, all data should be coming as IO values. If you don't see it, probably your device is not reporting it.
First configure the Teltonika FMC920 with an ELM327 or STN1110 OBDII device.
Then depending on the vehicle you might get the readings you are looking for.
Afterwards re configure your device to prioritize the OBDII readings over other parameters (i.e distance calculation).
Hope that helps,
Hello
Please could you help me see how I could receive OBDII data on my traccar platform? I would appreciate it if you have any procedure.