Queclink GL310MG

Hello,

I have a few Queclink GL310MG after using the GL300W for a long time.

Now I am used to set the GPS check rate to 60 seconds and the transmit frequency to 120 seconds, so it logs every 1 minute and transmits every 2 minutes.
With the GL300W the messages were sent as separate points to Traccar, 1 by 1.
With the GL310MG it looks like the points are bundled into 1 request?
When the device sends 2 waypoints to Traccar, only 1 waypoint is accepted by Traccar Server.

Does anyone know how to fix this so both are accepted?

Example with two waypoints from the log:

2021-05-21 12:23:32  INFO: [38f853a6] connected
2021-05-21 12:23:35  INFO: [38f853a6: gl200 < 90.134.45.73] +RESP:GTFRI,D40201,868239050304067,,0,16,2,2,4.0,265,-16.8,1.823300,50.932977,20210521102211,0208,0001,91E3,01467B06,2,4.6,177,-1.7,1.822265,50.931223,20210521102309,0208,0001,91E3,01467B06,,82,20210521102331,0631$
2021-05-21 12:23:35  INFO: [38f853a6] id: 868239050304067, time: 2021-05-21 12:22:11, lat: 50.93298, lon: 1.82330, speed: 2.2, course: 265.0
2021-05-21 12:23:39  INFO: [38f853a6] disconnected

Thank you.

Anton Tananaev4 years ago

Probably some decoder changes are required.

pling3 years ago

Hello.
Can this solve the problem?

Config by Queclink manage tool.
Open "Server connection" - "Backend server Registration Information"
scroll down to "other settings" and there you find "Multipacket Sending" checkbox.

I can read in the GL320M series Track Air Interface Protocoll V2.02

<Multi-packet Sending>: To disable or enable multi-packet sending.
0: Disable. If disabled, the device sends the buffered reports (if there are any) one by one.
1: Enable. If enabled, the device sends multiple buffered reports (If there are any) in one packet, and the lenght of the packet does not exceed 1460 bytes.