Engine Stop/Resume command not working
What protocol? Note that "success" for commands means that it has been sent to the device. It doesn't mean that device has accepted it. For that, you should check command response events.
Device is running on port 5013 ( hope that tells you about the protocol, I think its TK103 or 102 )
Command response event, do I need to change something in source code to parse that or does it logs it somewhere?
It's H02 protocol. Command response events are currently not supported for this protocol.
I have the same problem with a gps103 5001 I can not turn it off from traccar without sms I hope you can help us with this
@Milosoft, I would recommend you to calm down and not spam everywhere with your question.
Hi,
Whenever I try to send Engine Stop command using SMS (555) it does cut off relay on my device and engine stops working.
However, when I try to send a command from my web interface it says success message but it doesn't do anything to the device.
What could be the reason for this? Anybody else facing this issue?