Battery Problem
Yes, use attributes copying.
I've used this setting into traccar.xml
<entry key='processing.copyAttributes.enable'>true</entry>
<entry key='processing.copyAttributes'>battery</entry>But this doesn't change the situation, have you any suggestion??
If your device sends battery level (not voltage), then you need to use batteryLevel.
ok it works perfectly, thank you very much
Hi. I can't cope ... tried all the solutions from the forum and nothing ...
I have a Coban tk-102-2 device, gps103 protocol.
I'm trying to set the attributes to show me the battery level ... I was suggested by forum posts and it still doesn't work. Any help?
My device shows the battery status after calling them in the values 100, 75, 50, 25, 5. So if this information comes in a text message, the program should also display such information after setting the attributes.
Second issue ... regarding the alarm - low battery, I have a problem with that too. None of the attributes listed in the forum work. I sent the device a lowbatteryxxxxx on command, so it should be ok on the device side. What about the traccar?
Any suggestions?
Ideas?
Suggestion - start a new thread and provide details like logs, configuration etc.
Hi Anton
I searched in forum any solution for my problem, but i didn't found it.
The problem is the battery status, the protocol H02 of my GPS send value of battery every 3 minutes, and the gps position every 30 seconds, so the status of battery isn't visible for 3 minutes, my question is:
Is possible to show the previue percentage value of battery until that it update?
Thank you
SORRY FOR MY ENGLISH