Add protocol

Dear Administrator,
Along with greet
Is it possible to add the concox protocol for my CONCOX AT4 gps?

https://flespi.com/protocols/concox/at4
Thanks!

What makes you think it's not supported?

I am programming a test GPS with the GT06 protocol on port 5023 but apparently it is not decoding the payload sent, maybe I am wrong in the protocol

this I receive on my server:

2019-11-08 18:30:29  INFO: [c789f4c7: gt06 < 31.210.232.53] HEX: 797900a09404414c4d313d43353b414c4d323d43353b414c4d333d35373b535441313d32313b4459443d30313b534f533d2c2c3b43454e5445523d3b46454e43453d46656e63652c4f46462c302c302e3030303030302c302e3030303030302c3330302c494e206f72204f55542c313b49434349443d38393434353031373034313839323738353531463b4d4f44453d4d4f44452c312c3330302c313830303b00084da80d0a

and the coding is:

ALM1=C5;ALM2=C5;ALM3=57;STA1=21;DYD=01;SOS=,,;CENTER=;FENCE=Fence,OFF,0,0.000000,0.000000,300,IN or OUT,1;ICCID=8944501704189278551F;MODE=MODE,1,300,1800;

Did you find the correct port?

Hello,
Are there any news about supporting AT4 concox device ?

I think it was always supported.

Yes, i confirm it is working on 5023 port, thank you !